One-stop guide on how to get your webcam working inside of a GUI jail, including the microphone. Assumes you already have GUI set up inside the jail. My hardware: Ryzen Threadripper 3960x, NVIDIA 2080 RTX, Logitec C920 Webcam
- Background Info
- Load Kernel Modules
I reinstalled FreeBSD 12.1-RELEASE on my ThinkPad T480 and updated it to p10. In my saved configuration files, I copied my rc.conf to the new devices, loaded cuse and webcamd, everything looked fine until I loaded GNOME Cheese, which did not recognize the current devices. I fiddled with the...
I recently purchased a Logitech 1080p Pro Stream webcam, and I couldn't determine why it kept reporting usb_alloc_device: Failure selecting configuration index 0:USB_ERR_SHORT_XFER, port 4, addr 4 (ignored)
I have no idea why the OS would expect more data than it received, but I knew this was...
Hi! Is anyone using a TeVii S660 USB DVB-S2 receiver?
I'm using webcamd 220.127.116.11_1 on 12.1-RELEASE and webcamd says:
Attached to ugen1.3
Loading firmware at '/boot/modules/dvb-usb-s660.fw', f=8
Not sure if this one is supported or not. Sounds like one on the X200 is supposed to be: https://wiki.freebsd.org/WebcamCompat
I have cuse4bsd loaded. Can't get webcamd to work.
ugen3.2: <Chicony Electronics Co., Ltd. Integrated Camera> at usbus3, c
fg=0 md=HOST spd=HIGH (480Mbps) pwr=ON...
I want to use the Logitech HD Pro Webcam C920 on FreeBSD 12.0 but it does not seem to work. While searching the net several other people seemed to had success getting the webcam to work (except audio which is not important to my use case).
The webcam is supported in FreeBSD by...
Hi. I'm facing a problem regarding the operation of my webcam on FreeBSD 12.0-Release-p6. I have a Dell Inspiron running AMD E2 (64 bit) on 4 GB RAM.
I've installed webcamd, v4l_compat, libv4l and pwcview. My /boot/loader.conf has the entry cuse_load="YES" and
/etc/rc.conf has the entry...
To get your wacom bamboo fun CTH-661 working, start by installing xf86-input-wacom and adding this to your /etc/rc.conf:
devd_enable="YES" #To use a wacom tablet
webcamd_enable="YES" #To use a wacom tablet (and a webcam if you have it)
I'm trying to test if my camera Logictech C922 works with FreeBSD 11.2 installed on my system.
I want to view the video output and the following is webcamd output:
root@amd-sham:~ # webcamd
webcamd [-d ugen0.1] -N 0x1022-XHCI-root-HUB -S unknown -M 0
Hi everyone. I want to use my USB Logitech webcam in video calls. :)
The webcam works when using pwcview, but when using Cheese it doesn't ("There was an error playing video from the webcam"). When I try to use it with Firefox (WebRTC services), it never works; appear.in doesn't show anything...
I'm currently trying to get multimedia/webcamd and multimedia/motion working.
My webcam: Logitech C310 HD | Vendor/ProductID (hex): 0x046d:0x081b
I used these commands to install webcamd.
cd /usr/ports/multimedia/webcamd && BATCH=YES make "WITHOUT=HAL" "WITH=VT_CLIENT VT_SERVER"...