Dear guys,
I was installing new FreeBSD 7.2 on my laptop, but i didnt get IP assigned, i have tried.
with result
I dont know wat exactly the problem, any idea on this ?
Thanks.
*here some detail about my net card & machine.
output
output
I was installing new FreeBSD 7.2 on my laptop, but i didnt get IP assigned, i have tried.
Code:
dhclient re0
Code:
no link ................ giving up
Thanks.
*here some detail about my net card & machine.
Code:
ifconfig
Code:
re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=389b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_UCAST,WOL_MCAST,WOL_MAGIC>
ether 00:16:36:7f:6e:b6
media: Ethernet autoselect (10baseT/UTP <half-duplex>)
status: no carrier
ath0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 00:17:c4:00:b4:39
media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
status: no carrier
ssid "" channel 1 (2412 Mhz 11b)
authmode OPEN privacy OFF txpower 50 bmiss 7 scanvalid 60 bgscan
bgscanintvl 300 bgscanidle 250 roam:rssi11b 7 roam:rate11b 1 bintval 0
fwe0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8<VLAN_MTU>
ether 02:c0:9f:b5:57:26
ch 1 dma -1
fwip0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
lladdr 0.c0.9f.0.0.b5.57.26.a.2.ff.fe.0.0.0.0
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x5
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
Code:
dmesg | grep re0
Code:
re0: <RealTek 8168/8168B/8168C/8168CP/8168D/8111B/8111C/8111CP PCIe Gigabit Ethernet> port 0xa000-0xa0ff mem 0xc0200000-0xc0200fff irq 16 at device 0.0 on pci2
re0: Using 1 MSI messages
re0: Chip rev. 0x38000000
re0: MAC rev. 0x00000000
miibus0: <MII bus> on re0
re0: Ethernet address: 00:16:36:7f:6e:b6
re0: [FILTER]