root@router:~ # smartctl -a /dev/ada1
smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.1-RELEASE-p6 amd64] (local build)
Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Hitachi/HGST Deskstar 7K4000
Device Model: Hitachi HDS724040ALE640
Serial Number: PK1331PAH34G9S
LU WWN Device Id: 5 000cca 22bcf855d
Firmware Version: MJAOA3B0
User Capacity: 4,000,787,030,016 bytes [4.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: In smartctl database 7.3/5319
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Wed May 31 21:56:11 2023 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x84) Offline data collection activity
was suspended by an interrupting command from host.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 24) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 569) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 095 095 016 Pre-fail Always - 131081
2 Throughput_Performance 0x0005 136 136 054 Pre-fail Offline - 80
3 Spin_Up_Time 0x0007 126 126 024 Pre-fail Always - 622 (Average 600)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 180
5 Reallocated_Sector_Ct 0x0033 065 065 005 Pre-fail Always - 728
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 117 117 020 Pre-fail Offline - 36
9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 9352
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 179
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 317
193 Load_Cycle_Count 0x0012 100 100 000 Old_age Always - 317
194 Temperature_Celsius 0x0002 142 142 000 Old_age Always - 42 (Min/Max 19/61)
196 Reallocated_Event_Count 0x0032 001 001 000 Old_age Always - 3182
197 Current_Pending_Sector 0x0022 081 081 000 Old_age Always - 536
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 413 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 413 occurred at disk power-on lifetime: 3200 hours (133 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 60 7a 48 08 Error: UNC at LBA = 0x08487a60 = 138967648
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 40 80 28 7a 48 40 00 3d+07:46:07.583 READ FPDMA QUEUED
60 40 78 a8 e2 95 40 00 3d+07:46:07.583 READ FPDMA QUEUED
60 40 70 68 e2 95 40 00 3d+07:46:07.575 READ FPDMA QUEUED
60 40 68 e8 04 79 40 00 3d+07:46:07.575 READ FPDMA QUEUED
60 40 60 a8 04 79 40 00 3d+07:46:07.575 READ FPDMA QUEUED
Error 412 occurred at disk power-on lifetime: 3197 hours (133 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 e8 1a e7 06 Error: WP at LBA = 0x06e71ae8 = 115809000
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 08 90 a8 00 00 40 00 3d+05:01:15.658 WRITE FPDMA QUEUED
61 40 88 68 9e 00 40 00 3d+05:01:15.658 WRITE FPDMA QUEUED
61 40 80 28 9e 00 40 00 3d+05:01:15.658 WRITE FPDMA QUEUED
61 40 78 e8 9d 00 40 00 3d+05:01:15.657 WRITE FPDMA QUEUED
61 40 70 68 c9 03 40 00 3d+05:01:13.659 WRITE FPDMA QUEUED
Error 411 occurred at disk power-on lifetime: 3147 hours (131 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
10 51 40 e8 24 59 00 Error: IDNF at LBA = 0x005924e8 = 5842152
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 40 b8 e8 24 59 40 00 1d+03:13:41.540 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 1d+03:13:41.540 READ LOG EXT
60 40 a8 e8 24 59 40 00 1d+03:13:24.260 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 1d+03:13:24.259 READ LOG EXT
60 40 98 e8 24 59 40 00 1d+03:13:06.340 READ FPDMA QUEUED
Error 410 occurred at disk power-on lifetime: 3147 hours (131 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
10 51 40 e8 24 59 00 Error: IDNF at LBA = 0x005924e8 = 5842152
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 40 a8 e8 24 59 40 00 1d+03:13:24.260 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 1d+03:13:24.259 READ LOG EXT
60 40 98 e8 24 59 40 00 1d+03:13:06.340 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 1d+03:13:06.339 READ LOG EXT
61 10 88 e8 e3 56 40 00 1d+03:12:56.750 WRITE FPDMA QUEUED
Error 409 occurred at disk power-on lifetime: 3147 hours (131 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
10 51 38 f0 24 59 00 Error: IDNF at LBA = 0x005924f0 = 5842160
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 40 98 e8 24 59 40 00 1d+03:13:06.340 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 1d+03:13:06.339 READ LOG EXT
61 10 88 e8 e3 56 40 00 1d+03:12:56.750 WRITE FPDMA QUEUED
61 40 80 68 b3 d8 40 00 1d+03:12:52.753 WRITE FPDMA QUEUED
61 40 78 68 c9 03 40 00 1d+03:12:52.753 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 47539 -
# 2 Short offline Completed without error 00% 57 -
# 3 Extended offline Interrupted (host reset) 90% 10 -
# 4 Short offline Completed without error 00% 9 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.