I have installed ntop from ports and everything seems to be working a-okay. But this is only when ntop's NIC selection is set to the 3com ethernet card xl0. However, when I switch over to the NetFlow-device.2 NIC, the rrdtool graphs under Summary > Network Load completely disappear.
I've been all over the config three or four times and I cannot find where the glitch is at. If I switch back to the xl0 NIC, rrdtool graphs will start being displayed again. Finally, I am getting netflow traffic from the pfsense box and I've confirmed this with tcpdump plus ntop's own web interface.
Any thoughts are welcomed and thanks in advance!
John
I've been all over the config three or four times and I cannot find where the glitch is at. If I switch back to the xl0 NIC, rrdtool graphs will start being displayed again. Finally, I am getting netflow traffic from the pfsense box and I've confirmed this with tcpdump plus ntop's own web interface.
Any thoughts are welcomed and thanks in advance!
John