IOCAGE on a VPS

Don't know, doesn't iocage have something builtin? You might need to configure that to listen on the bridge interface and serve 10.0.0.0/24 addresses.
 
Here is what I have in my IOCAGE log file when I start my TEST jail.

Can anyone shed any light on what is wrong? I have installed dnsmasq on the host assuming it would provide an IP address to this jail but it doesn't seem to.

Code: 
Starting dhclient.
Starting Network: lo0 epair0b.
lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384
        options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6>
        inet 127.0.0.1 netmask 0xff000000
        inet6 ::1 prefixlen 128
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
        groups: lo
        nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
epair0b: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
        options=60001b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,RXCSUM_IPV6,TXCSUM_IPV6>
        ether fa:16:3e:2d:ff:20
        hwaddr 58:9c:fc:10:d5:2c
        inet6 fe80::f816:3eff:fe2d:ff20%epair0b prefixlen 64 scopeid 0x6
        groups: epair
        media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>)
        status: active
        nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
Waiting 30s for the default route interface: .............................





add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host 127.0.0.1: gateway lo0 fib 0: route already in table
add host ::1: gateway lo0 fib 0: route already in table
add net fe80::: gateway ::1
add net ff02::: gateway ::1
add net ::ffff:0.0.0.0: gateway ::1
add net ::0.0.0.0: gateway ::1
 
You must log in or register to reply here.
Back
Top