Hi,
I just joined the forum here after installing BSD, the actual process and everything went fine.
But I'm absolutely unable to get anywhere with getting internet through my usb dongle.
I've tried a veriety of things, listed below (all with no luck, under root):
Adding if_cdee_load="YES" , if_re_load="YES", if_rue_load="YES" to /boot/loader.conf (read somewhere that they may be needed).
Using
Using
Unplug and replug hub before using
Trying
Tried
For more info on this one I think I've entered my X.Y wrong, as now in ifconfig one less entry appears (which I believe was the usb to ethernet adapters one)
Also on startup I did get a message before:
ure0 on uhub 2
ure0: <Realtek USB 10/100/1000 LAN, class 0/0. rev 3.00/30.00. addr 8> on usbus0
miibus1: <MII bus> on ure0
rgephy1: <RTL8251/8153 1000BASE-T media interface> PHY0 on miibus1
rgephy1: none, 10baseT, 10baseT-FDX, 100baseTX, 1000baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
Although the last 2-3 there may be because off a bluetooth error (I can't tell, but there is one later on at startup, however I don't even use bluetooth so I don't care much if it's not working).
Thanks for any help/support, I really appreciate it!
I just joined the forum here after installing BSD, the actual process and everything went fine.
But I'm absolutely unable to get anywhere with getting internet through my usb dongle.
I've tried a veriety of things, listed below (all with no luck, under root):
Adding if_cdee_load="YES" , if_re_load="YES", if_rue_load="YES" to /boot/loader.conf (read somewhere that they may be needed).
Using
ifconfig -a
to find the device and then dhclient blahblahblah
to set it upUsing
dmesg
to get information on the device ping google.com
to make sure the internet isn't working (I get host name lookup failure)Unplug and replug hub before using
dhclient
againTrying
usbconfig
to get info on usb deviceTried
usbconfig -d X.Y set_config 1
from https://lists.freebsd.org/pipermail/freebsd-net/2015-June/042396.htmlFor more info on this one I think I've entered my X.Y wrong, as now in ifconfig one less entry appears (which I believe was the usb to ethernet adapters one)
Also on startup I did get a message before:
ure0 on uhub 2
ure0: <Realtek USB 10/100/1000 LAN, class 0/0. rev 3.00/30.00. addr 8> on usbus0
miibus1: <MII bus> on ure0
rgephy1: <RTL8251/8153 1000BASE-T media interface> PHY0 on miibus1
rgephy1: none, 10baseT, 10baseT-FDX, 100baseTX, 1000baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
Although the last 2-3 there may be because off a bluetooth error (I can't tell, but there is one later on at startup, however I don't even use bluetooth so I don't care much if it's not working).
Thanks for any help/support, I really appreciate it!