Hi everyone,
I have a freeBSD 8.1 box which has a usb serial adapter connected for access to a network switch's console. When you connect the adapter it shows up under dmesg(8) first under ugen and after under uplcom0.
The new device shows up as /dev/cuaU0 ok. But when I try to use
[cmd=]cu -l /dev/cuaU0 -s 115200[/cmd]
to connect is just says connected and freezes. From the switch guide it states the conn should be ANSI emulated 8n1 115200 bauds with no hardware flow control, but besides the speed I'm not sure how to configure the rest. Any help?
Thanks!
I have a freeBSD 8.1 box which has a usb serial adapter connected for access to a network switch's console. When you connect the adapter it shows up under dmesg(8) first under ugen and after under uplcom0.
The new device shows up as /dev/cuaU0 ok. But when I try to use
[cmd=]cu -l /dev/cuaU0 -s 115200[/cmd]
to connect is just says connected and freezes. From the switch guide it states the conn should be ANSI emulated 8n1 115200 bauds with no hardware flow control, but besides the speed I'm not sure how to configure the rest. Any help?
Thanks!