sound driver

I run FreeBSD13 arm (aarch64) on an M1 Mac Mini in a VMWare Fusion VM - how I could start the sound driver? As GUI I installed GNOME - in GNOME I see only ‘dummy output'

This is my first post on this forum - so here goes: I am currently using FreeBSD as a desktop system. My sound card is an ASUS Xonar D2X, which is only supported by audio/oss. I made a fresh install of FreeBSD 13.1-RELEASE and I compiled a custom kernel without any sound support before...

Hello everyone, I just installed FreeBSD 13.1 on my new PC which has an Intel Comet Lake PCH-LP cAVS sound card and unfortunately I can't get the sound to work. I understand from this link (https://github.com/freebsd/freebsd-src/blob/master/sys/dev/sound/pci/hda/hdac.h#L67) that the Intel...

I installed FreeBSD however I'm facing 3 problems related to hardware: WiFI is not working at all Front panel audio not working. Only rear audio (connected to the board) works Booting takes long with a message: "waiting 30s for the default route interface" Here's some info you may need to look...

I have a Fiio Olympus 2 audio interface (USB 2.0 -> 3.5mm jack) and would like to play audio through it (in FreeBSD 13.0). I've loaded the `snd_driver` metadriver which loaded in a bunch of audio drivers. Here's the output of cat /dev/sndstat: Installed devices: pcm0: <NVIDIA (0x0083) (HDMI/DP...

I figured out how to get sound working on my MacPro5,1 (mid 2010). Here's that thread. Basically: sudo vi /etc/sysctl.conf dev.hdaa.0.gpio_config="0=set 1=set" hw.snd.default_unit=3 Part of this makes sense (which unit is the default), and part of it is magic(0=set 1=set). I gather this is...