I have had on my MARVELL 88SE9230 card the following:
Oct 18 05:14:54 constance kernel: (ada5:ahcich7:0:0:0): Error 5, Periph was invalidated
Oct 18 05:14:54 constance kernel: (ada5:ahcich7:0:0:0): READ_FPDMA_QUEUED. ACB: 60 08 c8 3e ae 40 07 01 00 00 00 00
Oct 18 05:14:54 constance kernel...
I have two disks on my system:
ada0 at ata2 bus 0 scbus0 target 0 lun 0
ada0: <SanDisk SDSSDHP128G X2306RL> ATA8-ACS SATA 3.x device
ada0: Serial Number 133536406390
ada0: 300.000MB/s transfers (SATA 2.x, UDMA5, PIO 512bytes)
ada0: 122104MB (250069680 512 byte sectors)
ada1 at ata3 bus...
Serial Attached SCSI (SAS) has been around for a few years, but there hasn't been much news about them. There aren't that many consumer products out for it either.
I believe a SAS interface can run both Serial SCSI and SATA harddisks through the same type of cable. However, a SATA interface is...
we use a Supermicro server running FreeBSD 11.1-RELEASE to provide iSCSI devices based on zvol's for VMware.
The server has one zpool of 6 vdev raidz2 with 6 SATA disks in each, the server has HBA LSI 9300-8i installed. Periodically, the problem arises that the pool goes into DEGRADED...
I set a user and master password on a SATA disk drive and I can not unlock it since. After setting the pw, I've frozen the drive with camcontrol security -f
I can issue camcontrol inquiry successfully, but most other camcontrol commands fail. Especially, I can not unlock the drive...
I have two allegedly identical SanDisk SATA 3 SSD drives connected to my SATA 2 motherboard as a ZFS mirror. Until yesterday both these drives were happily operating in SATA2 mode at 300MB/s but now one of the drives (ada0) is only running in SATA 1 mode at 150MB/s.
I've swapped the drive...
Dear FreeBSD users,
Recently, I was working towards setting up a new zpool at work with freshly salvaged Western Digital and Seagate SATA hard drives (all 500 GB). However, FreeBSD 11.0-RC2 detects the drives as elements of bigger raid arrays (r0 and r1) in the arrangement 2x 500 GB + 2x 500...
I've solved this somewhat, but thought I'd bring it up here and see what comes of it. Been using FreeBSD for years on my home server, now wanted to test it out on my desktop machine.
Attempted to install 10.3-STABLE and 11-CURRENT but neither detected my Samsung 850 EVO SSD. Doesn't...
How can I grab the hard drive serial number in C on a machine running FreeBSD? The hard drive in question is an mSATA SSD. Specifically the TS256GMSA370.
In my searching I found the following on this forum: 9548
I receive the error 'Inappropriate ioctl for device' when running the following...