ZFS zohome - My Pool With All My Stuff - Disappeared

[atax1a]

from what we saw, samsung gives ISO images what contain automated firmware flashing tools on this page in the section below the Magician download https://semiconductor.samsung.com/consumer-storage/support/tools/

then you can either dig around on that for the image, or burn it to a disc and boot it.

 

[cy@]

I don't know if this applies to the OP situation, but I've been doing this as my default. Solaris I think wanted "whole device" but almost everything else partitions were better.

ZFS: do not give it all your HDD

Sometimes, holding out is the best decision.

www.freebsddiary.org

Solaris used its own partition table format, handled by the Solaris format(8) command. The format is similar to but also incompatible to bsdlabel. The OBP understood the format.

 

[malvarco]

I've noticed when a disk looks faulty for any reason to ZFS system, it totally ignores it, as if there was nothing there. Nor gpart show nor zfs import would show anything, but the disk is OK.
The only solution I've found is to boot from a FreeBSD install disk and go to shell or live and try zpool import. Then the disk would be marked as clean.
Then, when you boot normally, hopefully, you should be able to import the zpool again.