Ladies,
never experienced such bullshit like this port.
Even under Windows it is not a big thing to get your keyboard and mouse get working well.
So what is the solution?
dbus_enable="YES"
hald_enable="YES"
Section "ServerLayout"
Identifier "X.org Configured"
Screen 0 "Screen0" 0 0
InputDevice "Mouse0" "CorePointer"
InputDevice "Keyboard0" "CoreKeyboard"
[color="Blue"]Option "AllowEmptyInput" "False"[/color]
EndSection
vermaden said:Xorg releases are getting less quality all the time unfortunelly.
Last good release one was 7.2
vermaden said:Xorg releases are getting less quality all the time unfortunelly.
Last good release one was 7.2, 7.3 does not support virtual resolutions and higher refresh rates via modeline settings,
jb_fvwm2 said:good: xorg is working fine here, with 'nvidia'
took a lot of rebuilding, and a few fsck
bad: years of "agp.ko detected, aborting setup!" error
message upon X exit
..............
the latter is not a complaint. I just wish I knew more about
the options installing nvidia-driver. (No need to post them
here as I don't have time to rebuild...until something breaks)
adamk said:Virtual resolutions are not support, but custom modelines certainly are.
Adam
(...)
Section "Monitor"
Identifier "monitor0"
HorizSync 30 - 110
VertRefresh 48 - 170
Option "DPMS"
Modeline "640x480_120" 52.41 640 680 744 848 480 481 484 515 -HSync +Vsync
Modeline "1248x1024_100" 185.75 1248 1344 1480 1712 1024 1025 1028 1085 -HSync +Vsync
EndSection
Section "Screen"
Identifier "screen0"
Device "gfx0"
Monitor "monitor0"
DefaultDepth 24
SubSection "Display"
Modes "1248x1024_100" "640x480_120"
EndSubSection
Section "Monitor"
Identifier "monitor0"
HorizSync 30 - 110
VertRefresh 48 - 170
Option "DPMS"
Modeline "640x480_120" 52.41 640 680 744 848 480 481 484 515 -HSync +Vsync
Modeline "1248x1024_100" 185.75 1248 1344 1480 1712 1024 1025 1028 1085 -HSync +Vsync
[color="Red"]+ Option "PreferredMode" "1248x1024_100"[/color]
EndSection