I have created using netmao a bridge and setup an eiface interface in it for a vlan to connect to bgp (see below). But The ngeth0 interface created is setup as a 1000baseT interface. Is there a way to use the full 25G. Also will it redue the performances? Should I better setup the vlan at the swithch level for this interface to keep the perfomance and bandwidth?
ngctl configuration
Interface created :
ngctl configuration
Code:
mkpeer ql0: vlan lower downstream
name ql0:lower wan
mkpeer wan: bridge 102 link0
mkpeer wan: bridge 101 link0
msg wan: addfilter { vid=102 hook="102" }
msg wan: addfilter { vid=101 hook="101" }
name wan:102 bgpnet
name wan:101 home
msg ql0: setpromisc 1
msg ql0: setautosrc 0
mkpeer bgpnet: eiface link1 ether
EOF
ifconfig ngeth0 inet6 $HOST_IP6
Interface created :
Code:
# ifconfig ngeth0
ngeth0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=28<VLAN_MTU,JUMBO_MTU>
ether 58:9c:fc:10:a9:1c
inet6 <IPV6> prefixlen 64
inet6 fe80::5a9c:fcff:fe10:a91c%ngeth0 prefixlen 64 scopeid 0x8
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>