vlan over lagg

D

dellpe

Hello.

I have perfectly working lagg0 interface and it was fine and ok until I've tried to put VLANs over this lagg0. Here I have following hardware and configuration:

Huawei S5700-28C-SI with:
Code: 
interface Port-channel4
 description NasBox_FEC
 switchport trunk native vlan 10
 switchport trunk allowed vlan 40,1001
 switchport mode trunk

interface GigabitEthernet0/13
 description NASBOX_em0
 switchport trunk native vlan 10
 switchport trunk allowed vlan 40,1001
 switchport mode trunk
 speed 1000
 duplex full
 channel-protocol lacp
 channel-group 4 mode active
!
interface GigabitEthernet0/14
 description NASBOX_em1
 switchport trunk native vlan 10
 switchport trunk allowed vlan 40,1001
 switchport mode trunk
 speed 1000
 duplex full
 channel-protocol lacp
 channel-group 4 mode active

And FreeBSD 8RC1 with configured interface in rc.conf:
Code: 
cloned_interfaces="lagg0 vlan40 vlan1001"
ifconfig_lagg0="laggproto lacp laggport em0 laggport em1 192.168.10.10 netmask 255.255.255.0"
ifconfig_em0="up"
ifconfig_em1="up"
ifconfig_vlan40="inet 192.168.40.10 netmask 255.255.255.0 vlan 40 vlandev lagg0"
ifconfig_vlan1001="inet 192.168.20.10 netmask 255.255.255.0 vlan 1001 vlandev lagg0"

My problem is vlan(4) interfaces. As well as native works fine and I can with no problem at all work with lagg0 through native VLAN as badly I cannot access tagged VLANs vlan40 and vlan1001 interfaces.

Does any one know what I'm doing wrong?
 
Have you checked out rc.conf(5)? They present a couple of examples of creating vlans, which use a slightly different syntax than what you are using:
Code: 
To create a vlan device named em0.101 on em0 with the vlan tag 101 and the optional the IPv4 address 192.0.2.1/24:

vlans_em0="101"
ifconfig_em0_101="inet 192.0.2.1/24"

To create a vlan device named myvlan on em0 with the vlan tag 102:

vlans_em0="myvlan"
create_args_myvlan="vlan 102"
Disclaimer: This is from FreeBSD-10.0-RELEASE. I don't have a reference FreeBSD-8.0-RC1 system available to me so things might have changed in the interim.
 
You must log in or register to reply here.
Back
Top