cu
to view text onscreen while the GoFlex boots up.[CMD]cu -l /dev/cuaU1[/CMD]
Connected
My Prolific UART adapter shows up as port cuaU1. So I use this:
Code:[CMD]cu -l /dev/cuaU1[/CMD] Connected
I doubt if you blew it if you only using Rx, Tx, and ground. Did you use the graphic for hooking up the wires?
http://www.rudiswiki.de/wiki/DockSt...chFile&do=view&target=DockStar_serial_con.jpg
Black is pin2
1 3 5 7 9
2 4 6 8 10
1 2 3 4 5
6 7 8 9 10
1 2 3 4 5
10 9 8 7 6
cu -l /dev/cuaU0 -s 115200
U-Boot 2014.04.R2-1 (May 15 2014 - 14:36:05) Arch Linux ARM
Seagate GoFlex Home
(plus lots of other stuff...)
cu -l /dev/cuaU0 -s 115200
... and got:-
Code:U-Boot 2014.04.R2-1 (May 15 2014 - 14:36:05) Arch Linux ARM Seagate GoFlex Home (plus lots of other stuff...)
Is there any way to log the output from cuaU0?