Hail,
I have a Vantec USB enclosure and 4 disks on it. The VX35 from Seagate is the only I can't use smartctl(8) on.
I see this:
but I can't read a thing.
The apm-off command is useless:
I have the most updated smart tool from ports.
Is there anything I can do to make sure APM is off ?
Thanks,
10.1-RELEASE-p4 FreeBSD 10.1-RELEASE-p4
none
I have a Vantec USB enclosure and 4 disks on it. The VX35 from Seagate is the only I can't use smartctl(8) on.
smartctl -d sat -a /dev/da0
Code:
smartctl 6.3 2014-07-26 r3976 [FreeBSD 10.1-RELEASE-p4 amd64] (local build)
Copyright (C) 2002-14, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate SV35
Device Model: ST2000VX000-1ES164
Serial Number: xxxxxxxxxx
Firmware Version: 0958
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA/ATAPI-7 (minor revision not indicated)
Local Time is: Sun Mar 1 13:56:11 2015 BRT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART Status not supported: Incomplete response, ATA output registers missing
SMART overall-health self-assessment test result: PASSED
Warning: This result is based on an Attribute check.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x00) Offline data collection not supported.
SMART capabilities: (0x0000) Automatic saving of SMART data is not implemented.
Error logging capability: (0x00) Error logging NOT supported.
No General Purpose Logging support.
SMART Error Log not supported
SMART Self-test Log not supported
Selective Self-tests/Logging not supportedI see this:
Code:
SMART support is: Available - device has SMART capability.
SMART support is: EnabledThe apm-off command is useless:
/sbin/camcontrol cmd da0 -a "EF 85 00 00 00 00 00 00 00 00 00 00"
Code:
camcontrol: error sending commandI have the most updated smart tool from ports.
Is there anything I can do to make sure APM is off ?
Thanks,
10.1-RELEASE-p4 FreeBSD 10.1-RELEASE-p4
none
Last edited by a moderator: