Hi,
Withfreebsd FreeBSD 9.2 and a Siemens Speedstream 6520 in bridge mode, the PPPoE dial out mostly works, except that a ping to any of the website is not working yet.
Here is my
The /etc/resolve.conf file has the correct entry added with the ISP's nameserver IP addresses.
The /etc/ppp/ppp.conf file is shown as below:
I am not sure where it went wrong.
Any suggestion is very much appreciated.
Thanks
Sam
With
Here is my
ifconfig
info after PPPoE established a connection:
Code:
bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8009b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,LINKSTATE>
ether 00:14:22:d2:fe:d6
inet 10.0.0.2 netmask 0xffffff00 broadcast 10.0.0.255
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
iwi0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 2290
ether 00:16:6f:19:c5:85
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
status: no carrier
plip0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> metric 0 mtu 1500
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x9
inet 127.0.0.1 netmask 0xff000000
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
tun0: flags=8051<UP,POINTOPOINT,RUNNING,MULTICAST> metric 0 mtu 1492
options=80000<LINKSTATE>
inet 220.203.69.118 --> 220.203.1.152 netmask 0xffffff00
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
Opened by PID 1865
The /etc/resolve.conf file has the correct entry added with the ISP's nameserver IP addresses.
The /etc/ppp/ppp.conf file is shown as below:
Code:
default:
set log Phase Chat LCP IPCP CCP tun command
nat enable yes
nat same_ports yes
nat use_sockets yes
set redial 15 28800
set reconnect 15 28800
pppoe:
set device PPPoE:bge0:
set mru 1492
set mtu 1492
set speed sync
enable lqr
set lqrperiod 5
set cd 5
set dial
set login
set timeout 0
set authname [email]0386280775@vic.exetel.com.au[/email]
set authkey ispassword
set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
add default HISADDR
enable dns
I am not sure where it went wrong.
Any suggestion is very much appreciated.
Thanks
Sam