Post installation configuration

B

balanga

I found an item in the handbook about configuring my mouse post-installation here, but on further reading I find that sysinstall is no longer available!! So how am I supposed to go about post installation configuration?
 
It did nothing more than adding
Code: 
moused_enable="YES"
to /etc/rc.conf. However, this only works for PS/2 mice. USB mice are auto-detected and moused(8) is loaded automagically for them.
 
I'm using a laptop, so the mouse is neither PCS/2 or USB. Does that need some specific configuration?
 
Those are actually usually USB but use an internal connector.
 
You must log in or register to reply here.
Back
Top