Hey,
I've got a Verizon 4G modem, it identifies as LG VL600.
Here's related parts from dmesg output:
I've tried to use an ordinary modem (as umodem seem to create /dev/cuaU0 device for it) with ppp(8) with a config like (found somewhere on internet for other verizon modem):
But it doesn't work, the modem doesn't response to AT commands at all.
Any suggestion how to make this thing working? I wasn't able to google up anything related to this particular device on FreeBSD.
I've got a Verizon 4G modem, it identifies as LG VL600.
Code:
Manufacturer: LG Electronics Inc.
Model: VL600 136
Revision: S/W VER: VL600ZV3
ESN: 0x8063C55E
+GCAP: +CIS707-A, +CIS-856, CIS-856-A, +CGSM, +CLTE1
Here's related parts from dmesg output:
Code:
ugen2.2: <LG ELECTRONICSInc> at usbus2
cdce0: <LG ELECTRONICSInc LG UDC-AHB Subsystem, class 2/2, rev 2.00/1.00, addr 2> on usbus2
ue0: <USB Ethernet> on cdce0
ue0: Ethernet address: 64:99:5d:fb:07:2f
umodem0: <LG ELECTRONICSInc LG UDC-AHB Subsystem, class 2/2, rev 2.00/1.00, addr 2> on usbus2
umodem0: data interface 3, has CM over data, has break
I've tried to use an ordinary modem (as umodem seem to create /dev/cuaU0 device for it) with ppp(8) with a config like (found somewhere on internet for other verizon modem):
Code:
set device /dev/cuaU0
set speed 230400
set dial "ABORT BUSY ABORT NO\\sCARRIER TIMEOUT 5 \
\"\" AT OK-AT-OK ATE1Q0s7=60 OK \\dATDT\\T TIMEOUT 40 CONNECT"
set phone "#777"
# The authname and authkey are meaningless, but you need to have them set.
# Verizon's servers don't seem to care what you auth as.
set authname "doesn't matter"
set authkey "doesn't matter either"
set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
add default HISADDR # Add a (sticky) default route
enable dns
But it doesn't work, the modem doesn't response to AT commands at all.
Any suggestion how to make this thing working? I wasn't able to google up anything related to this particular device on FreeBSD.