Not sure if is the right place for this question.
On kernel config:
da, cd & pass, need scbus & ch to work properly or have nothing to do with that? I am asking because the are on the same section. I have no scsi controller on my mobo (Asus P5K3 deluxe) but I have da & cd (My system recognize my usb flash as da0s1 and my dvd-drive as cd0)
On kernel config:
Code:
# ATA/SCSI peripherals
#device scbus # SCSI bus (required for ATA/SCSI)
#device ch # SCSI media changers
device da # Direct Access (disks)
#device sa # Sequential Access (tape etc)
device cd # CD
device pass # Passthrough device (direct ATA/SCSI access)
#device ses # SCSI Environmental Services (and SAF-TE)da, cd & pass, need scbus & ch to work properly or have nothing to do with that? I am asking because the are on the same section. I have no scsi controller on my mobo (Asus P5K3 deluxe) but I have da & cd (My system recognize my usb flash as da0s1 and my dvd-drive as cd0)
