(II) Module "i2c" already built-in
(II) RADEON(0): ref_freq: 1432, min_out_pll: 64800, max_out_pll: 120000, min_in_pll: 100, max_in_pll: 1350, xclk: 40000, sclk: 500.000000, mclk: 400.000000
(II) RADEON(0): PLL parameters: rf=1432 rd=12 min=64800 max=120000; xclk=40000
(II) RADEON(0): Output VGA-0 using monitor section Monitor0
(II) RADEON(0): I2C bus "VGA-0" initialized.
(II) RADEON(0): Output DVI-0 has no monitor section
(II) RADEON(0): I2C bus "DVI-0" initialized.
(II) RADEON(0): Port0:
XRANDR name: VGA-0
Connector: VGA
CRT1: INTERNAL_KLDSCP_DAC1
DDC reg: 0x7e40
(II) RADEON(0): Port1:
XRANDR name: DVI-0
Connector: DVI-D
DFP1: INTERNAL_KLDSCP_LVTMA
DDC reg: 0x7e50
(II) RADEON(0): I2C device "VGA-0:E-EDID segment register" registered at address 0x60.
(II) RADEON(0): I2C device "VGA-0:ddc2" registered at address 0xA0.
(II) RADEON(0): Output: VGA-0, Detected Monitor Type: 0
Dac detection success
finished output detect: 0
(II) RADEON(0): I2C device "DVI-0:E-EDID segment register" registered at address 0x60.
(II) RADEON(0): I2C device "DVI-0:ddc2" registered at address 0xA0.
(II) RADEON(0): Output: DVI-0, Detected Monitor Type: 0
finished output detect: 1
finished all detect
before xf86InitialConfiguration
(II) RADEON(0): Output: VGA-0, Detected Monitor Type: 0
Dac detection success
(II) RADEON(0): Adding Screen mode: 1680x1050
(II) RADEON(0): Total number of valid Screen mode(s) added: 1
(II) RADEON(0): Output: DVI-0, Detected Monitor Type: 0
(II) RADEON(0): Output VGA-0 connected
(II) RADEON(0): Output DVI-0 disconnected
(II) RADEON(0): Using user preference for initial modes
(II) RADEON(0): Output VGA-0 using initial mode 1680x1050
after xf86InitialConfiguration
(==) RADEON(0): DPI set to (96, 96)
(II) Loading sub module "fb"
(II) LoadModule: "fb"
(II) Loading /usr/local/lib/xorg/modules//libfb.so
(II) Module fb: vendor="X.Org Foundation"
compiled for 1.6.1, module version = 1.0.0
ABI class: X.Org ANSI C Emulation, version 0.4
(==) RADEON(0): Using gamma correction (1.0, 1.0, 1.0)
(II) Loading sub module "ramdac"
(II) LoadModule: "ramdac"
(II) Module "ramdac" already built-in
(==) RADEON(0): Will attempt to use R6xx/R7xx EXA support if DRI is enabled.
(II) Loading sub module "exa"
(II) LoadModule: "exa"
(II) Loading /usr/local/lib/xorg/modules//libexa.so
(II) Module exa: vendor="X.Org Foundation"
compiled for 1.6.1, module version = 2.4.0
ABI class: X.Org Video Driver, version 5.0
(==) RADEON(0): Write-combining range (0x0,0x1000) was already clear
(!!) RADEON(0): For information on using the multimedia capabilities
of this adapter, please see http://gatos.sf.net.
(!!) RADEON(0): MergedFB support has been removed and replaced with xrandr 1.2 support
(--) Depth 24 pixmap format is 32 bpp
(II) do I need RAC? No, I don't.
(II) resource ranges after preInit:
[0] -1 0 0x000f0000 - 0x000fffff (0x10000) MX[B]
[1] -1 0 0x000c0000 - 0x000effff (0x30000) MX[B]
[2] -1 0 0x00000000 - 0x0009ffff (0xa0000) MX[B]
[3] 0 0 0x000a0000 - 0x000affff (0x10000) MS[B](OprU)
[4] 0 0 0x000b0000 - 0x000b7fff (0x8000) MS[B](OprU)
[5] 0 0 0x000b8000 - 0x000bffff (0x8000) MS[B](OprU)
[6] -1 0 0x0000ffff - 0x0000ffff (0x1) IX[B]
[7] -1 0 0x00000000 - 0x000000ff (0x100) IX[B]
[8] 0 0 0x000003b0 - 0x000003bb (0xc) IS[B](OprU)
[9] 0 0 0x000003c0 - 0x000003df (0x20) IS[B](OprU)
(II) RADEON(0): RADEONScreenInit d0000000 0 0
(==) RADEON(0): Write-combining range (0xa0000,0x10000) was already clear
Output CRT1 disable success
Blank CRTC 0 success
Disable CRTC 0 success
Disable CRTC memreq 0 success
Blank CRTC 1 success
Disable CRTC 1 success
Disable CRTC memreq 1 success
(II) RADEON(0): RADEONInitMemoryMap() :
(II) RADEON(0): mem_size : 0x20000000
(II) RADEON(0): MC_FB_LOCATION : 0x00df00c0
(II) RADEON(0): MC_AGP_LOCATION : 0x003f0000
(II) RADEON(0): Depth moves disabled by default
(II) RADEON(0): Allocating from a screen of 262144 kb
(II) RADEON(0): Will use 32 kb for hardware cursor 0 at offset 0x00af0000
(II) RADEON(0): Will use 32 kb for hardware cursor 1 at offset 0x00af4000
(II) RADEON(0): Will use 11200 kb for front buffer at offset 0x00000000
(II) RADEON(0): Will use 250912 kb for X Server offscreen at offset 0x00af8000
(II) RADEON(0): RADEONRestoreMemMapRegisters() :
(II) RADEON(0): MC_FB_LOCATION : 0x00df00c0 0x00df00c0
(II) RADEON(0): MC_AGP_LOCATION : 0x003f0000
(==) RADEON(0): Backing store disabled
(WW) RADEON(0): Direct rendering disabled
(EE) RADEON(0): Acceleration initialization failed
(II) RADEON(0): Acceleration disabled
(II) RADEON(0): DPMS enabled
(==) RADEON(0): Silken mouse enabled
(II) RADEON(0): Textured video requires CP on R5xx/R6xx/R7xx/IGP
Output CRT1 disable success
(II) RADEON(0): DIG0 transmitter: Coherent Mode enabled
Output DIG0 transmitter setup success
Blank CRTC 0 success
Disable CRTC 0 success
Disable CRTC memreq 0 success
Blank CRTC 1 success
Disable CRTC 1 success
Disable CRTC memreq 1 success
Output CRT1 disable success
Mode 1680x1050 - 2240 1089 6
(II) RADEON(0): RADEONRestoreMemMapRegisters() :
(II) RADEON(0): MC_FB_LOCATION : 0x00df00c0 0x00df00c0
(II) RADEON(0): MC_AGP_LOCATION : 0x003f0000
freq: 146250000
best_freq: 146243000
best_feedback_div: 817
best_ref_div: 10
best_post_div: 8
(II) RADEON(0): crtc(0) Clock: mode 146250, PLL 146240
(II) RADEON(0): crtc(0) PLL : refdiv 10, fbdiv 0x331(817), pdiv 8
Set CRTC 0 PLL success
Set CRTC Timing success
Set CRTC 0 Overscan success
Not using RMX
scaler 0 setup success
Set CRTC 0 Source success
crtc 0 YUV disable setup success
Output DAC1 setup success
Enable CRTC memreq 0 success
Enable CRTC 0 success
Unblank CRTC 0 success
Output CRT1 enable success
(II) RADEON(0): DIG0 transmitter: Coherent Mode enabled
Output DIG0 transmitter setup success
Blank CRTC 1 success
Disable CRTC 1 success
Disable CRTC memreq 1 success
(II) RADEON(0): RandR 1.2 enabled, ignore the following RandR disabled message.
(--) RandR disabled
(II) Initializing built-in extension Generic Event Extension
(II) Initializing built-in extension SHAPE
(II) Initializing built-in extension MIT-SHM
(II) Initializing built-in extension XInputExtension
(II) Initializing built-in extension XTEST
(II) Initializing built-in extension BIG-REQUESTS
(II) Initializing built-in extension SYNC
(II) Initializing built-in extension XKEYBOARD
(II) Initializing built-in extension XC-MISC
(II) Initializing built-in extension XINERAMA
(II) Initializing built-in extension XFIXES
(II) Initializing built-in extension RENDER
(II) Initializing built-in extension RANDR
(II) Initializing built-in extension COMPOSITE
(II) Initializing built-in extension DAMAGE
(II) AIGLX: Loaded and initialized /usr/local/lib/dri/swrast_dri.so
(II) GLX: Initialized DRISWRAST GL provider for screen 0
(II) RADEON(0): Setting screen physical size to 444 x 277
(II) config/hal: Adding input device USB Optical Mouse
(II) LoadModule: "mouse"
(II) Loading /usr/local/lib/xorg/modules/input//mouse_drv.so
(II) Module mouse: vendor="X.Org Foundation"
compiled for 1.6.1, module version = 1.4.0
Module class: X.Org XInput Driver
ABI class: X.Org XInput driver, version 4.0
(**) USB Optical Mouse: Device: "/dev/sysmouse"
(==) USB Optical Mouse: Protocol: "Auto"
(**) USB Optical Mouse: always reports core events
(**) Option "Device" "/dev/sysmouse"
(==) USB Optical Mouse: Emulate3Buttons, Emulate3Timeout: 50
(**) USB Optical Mouse: ZAxisMapping: buttons 4 and 5
(**) USB Optical Mouse: Buttons: 9
(**) USB Optical Mouse: Sensitivity: 1
(II) XINPUT: Adding extended input device "USB Optical Mouse" (type: MOUSE)
(**) USB Optical Mouse: (accel) keeping acceleration scheme 1
(**) USB Optical Mouse: (accel) filter chain progression: 2.00
(**) USB Optical Mouse: (accel) filter stage 0: 20.00 ms
(**) USB Optical Mouse: (accel) set acceleration profile 0
(II) USB Optical Mouse: SetupAuto: hw.iftype is 4, hw.model is 0
(II) USB Optical Mouse: SetupAuto: protocol is SysMouse
(II) config/hal: Adding input device AT Keyboard
(II) LoadModule: "kbd"
(II) Loading /usr/local/lib/xorg/modules/input//kbd_drv.so
(II) Module kbd: vendor="X.Org Foundation"
compiled for 1.6.1, module version = 1.3.2
Module class: X.Org XInput Driver
ABI class: X.Org XInput driver, version 4.0
(**) AT Keyboard: always reports core events
(**) Option "Protocol" "standard"
(**) AT Keyboard: Protocol: standard
(**) Option "AutoRepeat" "500 30"
(**) Option "XkbRules" "xorg"
(**) AT Keyboard: XkbRules: "xorg"
(**) Option "XkbModel" "pc105"
(**) AT Keyboard: XkbModel: "pc105"
(**) Option "XkbLayout" "us"
(**) AT Keyboard: XkbLayout: "us"
(**) Option "CustomKeycodes" "off"
(**) AT Keyboard: CustomKeycodes disabled
(II) XINPUT: Adding extended input device "AT Keyboard" (type: KEYBOARD)
(II) UnloadModule: "mouse"
(II) UnloadModule: "kbd"
Output CRT1 disable success
Blank CRTC 0 success
Disable CRTC 0 success
Disable CRTC memreq 0 success
Blank CRTC 1 success
Disable CRTC 1 success
Disable CRTC memreq 1 success
(II) RADEON(0): RADEONRestoreMemMapRegisters() :
(II) RADEON(0): MC_FB_LOCATION : 0x00df00c0 0x00df00c0
(II) RADEON(0): MC_AGP_LOCATION : 0x00000000
(II) RADEON(0): avivo_restore !
Enable CRTC memreq 0 success
Enable CRTC 0 success
Unblank CRTC 0 success
(==) RADEON(0): Write-combining range (0xa0000,0x10000) was already clear
home2#