Hello!
Is my understanding correct that FreeBSD iSCSI initiator currently has no multipathing support?
I have an EMC Celerra NX4 device which I'm accessing from several Linux boxes via multipathing - each Linux box has two NICs which connect to two interfaces on the Celerra via two separate switches. If one network path fails, the traffic continues via remaining paths and the situation is completely transparent for hosts.
I was hoping to add a FreeBSD 7.3 box to this solution, but after reviewing iscsi_target and iscsi.conf manual pages I can't think of a way to set up multipathing. Any suggestions?
Is my understanding correct that FreeBSD iSCSI initiator currently has no multipathing support?
I have an EMC Celerra NX4 device which I'm accessing from several Linux boxes via multipathing - each Linux box has two NICs which connect to two interfaces on the Celerra via two separate switches. If one network path fails, the traffic continues via remaining paths and the situation is completely transparent for hosts.
I was hoping to add a FreeBSD 7.3 box to this solution, but after reviewing iscsi_target and iscsi.conf manual pages I can't think of a way to set up multipathing. Any suggestions?