Hi,
I want to statically configure server IP6 addresses but continue to allow the installation of the default route as learnt from RAs. Is this possible?
creates the correct IP6 address and installs the default router as learnt via RAs, but also configures a SLAAC address (which I'd prefer not to have).
Or must I also turn off
Also a side question - is there a way to dynamically learn the link's network but hard code the host part? ie:, learn
Thanks.
ps. I couldn't add any tags when I created this post (field was not allowing text entry) and then I couldn't figure out how to add tags after.
I want to statically configure server IP6 addresses but continue to allow the installation of the default route as learnt from RAs. Is this possible?
ifconfig_vmx0_ipv6="inet6 2001:0DB8:10::10.10.10.10 prefer_source accept_rtadv -autoconf"creates the correct IP6 address and installs the default router as learnt via RAs, but also configures a SLAAC address (which I'd prefer not to have).
Or must I also turn off
accept_rtadv and hard code a default?Also a side question - is there a way to dynamically learn the link's network but hard code the host part? ie:, learn
2001:0DB8:10::/64 from an RA but specify just ::10.10.10.10 in rc.conf? My servers all use their IPv4 address as their host part of the IP6 address.Thanks.
ps. I couldn't add any tags when I created this post (field was not allowing text entry) and then I couldn't figure out how to add tags after.