Hello,
I have a PC with Intel Desktop Board DH77EB that has an onboard Intel 82579V Gigabit Ethernet Controller as the NIC. I have a WLAN setup and I was connecting this PC using a wireless USB adaptor earlier (Digisol DG-WN3300N - urtwn driver). This used to work fine until I enabled WPA2 security on the WLAN. My WLAN router has 4 LAN ports so I removed the USB adaptor and connected the PC directly using a RJ45 patch cord to the router and enable em driver in the loader.conf and configured it appropriately in rc.conf.
Now I can see that em0 is UP and active if I run
My WLAN continues to work fine as other PC on wireless as well as wired to the router can talk to each other.
I also tried setting hw.pci.realloc_bars=1 and hint.agp.0.disabled=1 and also disabled Intel Virtualisation in the BIOS. Still no luck...
Can someone please help?
Many thanks,
Nitin
I have a PC with Intel Desktop Board DH77EB that has an onboard Intel 82579V Gigabit Ethernet Controller as the NIC. I have a WLAN setup and I was connecting this PC using a wireless USB adaptor earlier (Digisol DG-WN3300N - urtwn driver). This used to work fine until I enabled WPA2 security on the WLAN. My WLAN router has 4 LAN ports so I removed the USB adaptor and connected the PC directly using a RJ45 patch cord to the router and enable em driver in the loader.conf and configured it appropriately in rc.conf.
Now I can see that em0 is UP and active if I run
ifconfig
and I am also able to ping the IP address associated with em0. However, I am unable to ping the router or any other PCs in the network.My WLAN continues to work fine as other PC on wireless as well as wired to the router can talk to each other.
I also tried setting hw.pci.realloc_bars=1 and hint.agp.0.disabled=1 and also disabled Intel Virtualisation in the BIOS. Still no luck...
Can someone please help?
Many thanks,
Nitin