Hi everyone!
I got an Acer easyStore H340 NAS box which has the Marvell Yukon 88E8071 gigabit network adapter. I run FreeNAS 8 (which bases on FreeBSD, thats why I'm here) on it. The network interface gets detected by the correct driver and it works. Until I copy something from my PC to the NAS. For some (varying) seconds, I get transfer rates of ~50MB/s and then suddenly copying stops because the network connection is lost.
I attached display and keyboard to the easyStore and did
I also added the following lines to /etc/loader.conf:
like suggested at http://forums.freenas.org/showthrea...ng-when-copying-data-to-it&highlight=stalling although I do not get the mentioned watchdog warnings.
Can someone help me finding the cause for this issue?
Thanks in Advance
Moritz
I got an Acer easyStore H340 NAS box which has the Marvell Yukon 88E8071 gigabit network adapter. I run FreeNAS 8 (which bases on FreeBSD, thats why I'm here) on it. The network interface gets detected by the correct driver and it works. Until I copy something from my PC to the NAS. For some (varying) seconds, I get transfer rates of ~50MB/s and then suddenly copying stops because the network connection is lost.
I attached display and keyboard to the easyStore and did
ifconfig msk0 down && ifconfig msk0 up
then the connection was back up again. I already tried adding -rxcsum to the interface options like was suggested for the old Marvell drivers for FreeBSD 7.I also added the following lines to /etc/loader.conf:
Code:
hw.nfe.msi_disable = "1"
hw.nfe.msix_disable = "1"
hw.pci.enable_msix=0
hw.pci.enable_msi=0
Can someone help me finding the cause for this issue?
Thanks in Advance
Moritz