hello folks,
I am stuck on the following problem, I only recognize with FreeBSD. I am using aiwn0:
which works by now for WPA quite good. However I am stuck at changing my MAC address of the device. If I do so wpa_supplicant, which was working before perfectly is not able anymore to keep the association:
I changed the MAC address like:
all this is working without any problem for ethernet cards.
UPDATE:
During writing this I tried to change the MAC of the iwn0 as well, and it works!
So, it is crucial to adjust both addresses to get it proper working, which makes sense as wlan0 is just a virtual device of iwn0.
Thanks for the help
I am stuck on the following problem, I only recognize with FreeBSD. I am using aiwn0:
Code:
<Intel(R) Centrino(R) Ultimate-N 6300> mem 0xf2500000-0xf2501fff irq 17 at device 0.0 on pci3
Code:
Trying to associate with xx:xx:xx:xx:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
CTRL-EVENT-DISCONNECTED bssid=xx:xx:xx:xx:xx:xx reason=0
Trying to associate with xx:05:43:f5:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
CTRL-EVENT-DISCONNECTED bssid=xx:xx:xx:xx:xx:xx reason=0
Trying to associate with xx:xx:xx:xx:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
CTRL-EVENT-DISCONNECTED bssid=xx:xx:xx:xx:xx:xx reason=0
Trying to associate with xx:xx:xx:xx:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
CTRL-EVENT-DISCONNECTED bssid=xx:xx:xx:xx:xx:xx reason=0
Trying to associate with xx:xx:xx:xx:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
CTRL-EVENT-DISCONNECTED bssid=xx:xx:xx:xx:xx:xx reason=0
Trying to associate with xx:xx:xx:xx:xx:xx (SSID='myWPAnet' freq=2412 MHz)
Associated with xx:xx:xx:xx:xx:xx
I changed the MAC address like:
Code:
ifconfig wlan0 mac 00:55:55:55:55:55
all this is working without any problem for ethernet cards.
UPDATE:
During writing this I tried to change the MAC of the iwn0 as well, and it works!
Code:
ifconfig iwn0 mac 00:55:55:55:55:55
So, it is crucial to adjust both addresses to get it proper working, which makes sense as wlan0 is just a virtual device of iwn0.
Thanks for the help