# kldload ./rt28600.ko
rt28600: <RT2790 PCIe> mem 0xfbef0000-0xfbefffff irq 19 at device 0.0 on pci1
rt28600: attaching
rt28600: EEPROM rev=0x0102
rt28600: EEPROM mac address=00:22:43:42:25:27
rt28600: EEPROM RF rev=0x0003, paths=1T2R
rt28600: EEPROM NIC config: Tx AGC control=0
rt28600: EEPROM country code=1/7
rt28600: EEPROM freq offset=0x1c
rt28600: EEPROM led cntl=0x01, LEDs=0xffff/0x9ad9/0xc8cc
rt28600: EEPROM LNA gains=0x00/0xff
rt28600: invalid EEPROM LNA gain: 2
rt28600: invalid EEPROM LNA gain: 3
rt28600: EEPROM Tx power compensation deltas=0(2MHz), 0(5MHz)
rt28600: EEPROM Tx power compensation #0=0x66663333(20MHz), 0x66663333(40MHz/2GHz), 0x66663333(40MHz/5GHz)
rt28600: EEPROM Tx power compensation #1=0x66666666(20MHz), 0x66666666(40MHz/2GHz), 0x66666666(40MHz/5GHz)
rt28600: EEPROM Tx power compensation #2=0x33333333(20MHz), 0x33333333(40MHz/2GHz), 0x33333333(40MHz/5GHz)
rt28600: EEPROM Tx power compensation #3=0x66663333(20MHz), 0x66663333(40MHz/2GHz), 0x66663333(40MHz/5GHz)
rt28600: EEPROM Tx power compensation #4=0xffff6666(20MHz), 0xffff6666(40MHz/2GHz), 0xffff6666(40MHz/5GHz)
rt28600: EEPROM TSSI 2GHz: 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, step=255
rt28600: EEPROM TSSI 5GHz: 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, step=255
rt28600: MAC/BBP RT2860 (rev 0x28720200), RF RT2720
rt28600: skip channel 10, could not find extension channel
rt28600: skip channel 11, could not find extension channel
rt28600: skip channel 12, could not find extension channel
rt28600: skip channel 13, could not find extension channel
rt28600: skip channel 14, could not find extension channel
rt28600: [ITHREAD]
wlan0: Ethernet address: 00:22:43:42:25:27
rt28600: initializing
rt28600: loading 8051 microcode
rt28600: 8051 microcode was successfully loaded
wlan0: ieee80211_new_state_locked: pending INIT -> SCAN transition lost