Hi, this is the first time that see this...is very strange
in /etc/rc.conf I have (change the ip address for the post):
it boots like this:
and when I do "service netif restart"
the ouput is this
wait a little,do a "ifconfig" and i got
also I do "dhclient re1" (I have one dhcp server on the network)
then I do "ifconfig re1 up" and "dhclient re1" give me this
It happend with one FreeBSD server lask week..the ethernet link is active but ifconfig says "no carrier"
so, I change the network card and it works...but now is my box
btw the network card that "failed" was bge0 , so , is not realtek problem
the network switchs are cisco bussines 220 series, gigabit
when I do service netif restart,the ethernet port in the switch are shutdown and up again
the same when I do "dhclient re1"
any clue? I am lost
sorry, the two boxes in cuestion are FreeBSD-14.0-RELEASE
in /etc/rc.conf I have (change the ip address for the post):
Code:
ifconfig_re1="inet 192.168.0.2 netmask 255.255.255.0"
defaultrouter="192.168.0.1"
it boots like this:
Code:
re1: flags=1008802<BROADCAST,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
ether 3c:7c:3f:0e:e3:04
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
and when I do "service netif restart"
the ouput is this
Code:
re1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
ether 3c:7c:3f:0e:e3:04
inet 192.168.0.2 netmask 0xffff0000 broadcast 192.168.255.255
media: Ethernet autoselect (none)
status: no carrier
wait a little,do a "ifconfig" and i got
Code:
re1: flags=1008802<BROADCAST,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
ether 3c:7c:3f:0e:e3:04
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
also I do "dhclient re1" (I have one dhcp server on the network)
Code:
DHCPREQUEST on re1 to 255.255.255.255 port 67
Interface re1 is down, dhclient exiting
then I do "ifconfig re1 up" and "dhclient re1" give me this
Code:
re1: no link .... got link
DHCPREQUEST on re1 to 255.255.255.255 port 67
Interface re1 is down, dhclient exiting
It happend with one FreeBSD server lask week..the ethernet link is active but ifconfig says "no carrier"
so, I change the network card and it works...but now is my box
btw the network card that "failed" was bge0 , so , is not realtek problem
the network switchs are cisco bussines 220 series, gigabit
when I do service netif restart,the ethernet port in the switch are shutdown and up again
the same when I do "dhclient re1"
any clue? I am lost
sorry, the two boxes in cuestion are FreeBSD-14.0-RELEASE