I have just done a clean install on a new disk
and I am now getting error messages ==>
I had seen these before on the older disk, which I thought was failing!
That was running 10.2-Beta
From the dmesg
Line 135 repeats ad infinitum
What is the cause and remedy for this?
Thanks!
uname -a
Code:
FreeBSD MACH1 10.2-RELEASE FreeBSD 10.2-RELEASE #0 r286666: Wed Aug 12 19:31:38 UTC 2015 root@releng1.nyi.freebsd.org:/usr/obj/usr/src/sys/GENERIC i386
and I am now getting error messages ==>
Code:
ATA1: error issuing ATA PACKET command
I had seen these before on the older disk, which I thought was failing!
That was running 10.2-Beta
From the dmesg
Code:
root@MACH1:/ # dmesg | grep -in ata1
41:atapci0: <SiI 3114 SATA150 controller> port 0xa400-0xa407,0xa800-0xa803,0xac00-0xac07,0xb000-0xb003,0xb400-0xb40f mem 0xe6000000-0xe60003ff irq 5 at device 10.0 on pci0
58:ata1: <ATA channel> at channel 1 on atapci2
118:cd0 at ata1 bus 0 scbus7 target 0 lun 0
123:cd1 at ata1 bus 0 scbus7 target 1 lun 0
135:ata1: error issuing ATA PACKET command
Line 135 repeats ad infinitum
What is the cause and remedy for this?
Thanks!