I'm unable to get the eMachine to output sound through the HDMI cable. It works fine out of the 3.5mm jack.
After I type
switches pcm2 to default but still no sound.
Looking at pciconf I think that a driver might not be recognised:
snd_driver_load is set in rc.conf. AFAIK this loads all available audio drivers. Does this mean that FreeBSD doesn't currently support HDMI sound for this graphics card (GeForce 9200)? x11/nvidia-driver is installed, I'm not sure if that is what supports the HDMI audio though.
I have seen similar threads on here sending the users to nvidia support so I will do the same if there haven't been any revelations since the other threads. Is there anything I haven't checked yet?
Code:
FreeBSD Audio Driver (newpcm: 32bit 2009061500/i386)
Installed devices:
pcm0: <HDA Realtek ALC662 PCM #0 Analog> (play/rec) default
pcm1: <HDA Realtek ALC662 PCM #1 Digital> (play)
pcm2: <HDA NVidia MCP78 HDMI PCM #0 Digital> (play)
After I type
# sysctl hw.snd.default_unit=2
switches pcm2 to default but still no sound.
Looking at pciconf I think that a driver might not be recognised:
Code:
hdac0@pci0:0:7:0: class=0x040300 card=0x04481025 chip=0x077410de rev=0xa1 hdr=0x00
vendor = 'NVIDIA Corporation'
class = multimedia
subclass = HDA
snd_driver_load is set in rc.conf. AFAIK this loads all available audio drivers. Does this mean that FreeBSD doesn't currently support HDMI sound for this graphics card (GeForce 9200)? x11/nvidia-driver is installed, I'm not sure if that is what supports the HDMI audio though.
I have seen similar threads on here sending the users to nvidia support so I will do the same if there haven't been any revelations since the other threads. Is there anything I haven't checked yet?