I have a LSI card, the firmware shows it is LSI 1068E SAS IR firmware. I want to use ZFS on it, do I need to flash IR firmware to IT firmware? I do nothing (not set RAID in the card firmware), I can set the ZFS pool, this is not good? Which are the recommendations?
My OS is 8.1 and dmesg info is :
My OS is 8.1 and dmesg info is :
Code:
mpt0: <LSILogic SAS/SATA Adapter> port 0xe000-0xe0ff mem 0xfb7fc000-0xfb7fffff,0xfb7e0000-0xfb7effff irq 24 at device 0.0 on pci7
mpt0: [ITHREAD]
mpt0: MPI Version=1.5.19.0
mpt0: Capabilities: ( RAID-0 RAID-1E RAID-1 )
mpt0: 0 Active Volumes (2 Max)
mpt0: 0 Hidden Drive Members (14 Max)
Code:
da0 at mpt0 bus 0 scbus0 target 0 lun 0
da0: <ATA ST3500418AS CC46> Fixed Direct Access SCSI-5 device
da0: 300.000MB/s transfers
da0: Command Queueing enabled
da0: 476940MB (976773168 512 byte sectors: 255H 63S/T 60801C)
da1 at mpt0 bus 0 scbus0 target 1 lun 0
da1: <ATA ST3500418AS CC46> Fixed Direct Access SCSI-5 device
da1: 300.000MB/s transfers
da1: Command Queueing enabled
da1: 476940MB (976773168 512 byte sectors: 255H 63S/T 60801C)