Hi,
Running FreeBSD-11.1 on a recent laptop, ASUS, seems to work fine, except when I try to get a DHCP lease through a USB-Hub with attached RJ45.
I get following error message at the end of the boot :
DHCP is not working .... The only way to get a lease is to unplug the hub , to plug it again and then
Is there another solution ??
Regards
Running FreeBSD-11.1 on a recent laptop, ASUS, seems to work fine, except when I try to get a DHCP lease through a USB-Hub with attached RJ45.
I get following error message at the end of the boot :
Code:
usb_alloc_device: set address 5 failed (USB_ERR_TIMEOUT, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed, USB_ERR_TIMEOUT
usbd_req_re_enumerate: addr=5, set address failed! (USB_ERR_TIMEOUT, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed, USB_ERR_TIMEOUT
usbd_req_re_enumerate: addr=5, set address failed! (USB_ERR_TIMEOUT, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed, USB_ERR_TIMEOUT
usbd_req_re_enumerate: addr=5, set address failed! (USB_ERR_TIMEOUT, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed, USB_ERR_TIMEOUT
usbd_req_re_enumerate: addr=5, set address failed! (USB_ERR_TIMEOUT, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed, USB_ERR_TIMEOUT
ugen0.5: <Unknown > at usbus0 (disconnected)
uhub_reattach_port: could not allocate new device
ugen0.5: <VIA Labs, Inc. USB3.0 Hub> at usbus0
uhub2 on uhub0
uhub2: <VIA Labs, Inc. USB3.0 Hub, class 9/0, rev 3.00/3.45, addr 5> on usbus0
#uhub2 on uhub0
uhub2: <VIA Labs, Inc. USB3.0 Hub, class 9/0, rev 3.00/3.45, addr 5> on usbus0
uhub2: 4 ports with 4 removable, self powered
ugen0.6: <Realtek USB 101001000 LAN> at usbus0
ums0 on uhub0
ums0: <Logitech USB Receiver, class 0/0, rev 2.00/12.03, addr 1> on usbus0
ums0: 16 buttons and [XYZT] coordinates ID=2
uhid0 on uhub0
uhid0: <Logitech USB Receiver, class 0/0, rev 2.00/12.03, addr 1> on usbus0
cdce0 on uhub2
cdce0: <CDC Communications Control> on usbus0
ue0: <USB Ethernet> on cdce0
ue0: Ethernet address: 00:e0:4c:68:12:85
DHCP is not working .... The only way to get a lease is to unplug the hub , to plug it again and then
dhclient ue0
works ...Is there another solution ??
Regards
Last edited by a moderator: