I have FreeBSD 8.0 and ath interface. How to configure wireless to connect to internet over WPA?
juve_inferno said:I create wlan0 device, configure loader.conf and wpa_supplicant.conf
In list i see my wireless network but when type dhclient wlan0 there are message wlan0: no link ......Code:network={ ssid="D-Link" psk="****" }
wlans_ath0="wlan0"
create_args_wlan0="regdomain XXX country YYY"
ifconfig_wlan0="WPA DHCP"
# ifconfig wlan0 list countries | more
wlan_wep_load="YES"
wlan_ccmp_load="YES"
wlan_tkip_load="YES"
wlans_ath0="wlan0"
ifconfig_wlan0="WPA DHCP"
network={
ssid="D-Link"
psk="****"
}
juve_inferno said:Is there a way to connect manual with commands? Because each change in network i would have to reset computer.
juve_inferno said:I try with SSID Broadcast enabled and disabled but nothing. Router is configured to United States region.
ap_scan=1
juve_inferno said:Now when call ifconfig wlan0 is connected to my wireless network but when ping some web site or router "No route to host". Router assigns IP addresses based on MAC addresses of card.