Hello.
I try to configure Banana BPI-R1 device with Broadcom BCM53125 (5 ports). Can't setup it in FreeBSD.
In Debian, router setup look like this:
How to do same things in FreeBSD?
I try to configure Banana BPI-R1 device with Broadcom BCM53125 (5 ports). Can't setup it in FreeBSD.
In Debian, router setup look like this:
Code:
# Reset switch, counter and enable vlan mode
device=eth0
swconfig dev $device set reset 1
swconfig dev $device set reset_mib 1
swconfig dev $device set enable_vlan 1
# configure vlans
swconfig dev $device vlan 101 set ports "3 8t"
swconfig dev $device vlan 102 set ports "2 1 0 4 8t"
# activate new config
swconfig dev $device set apply 1How to do same things in FreeBSD?
Last edited:
