Any difference between service start and enable in rc.conf?

[Anthie]

Is there any difference between service start and enable in rc.conf?
PF cannot get ipv6 addresses of tunnel broker interface gif0 when enabled in rc.conf and runs properly when service pf start by root.

 

[SirDice]

Re: Any difference between service start and enable in rc.co

Is there any difference between service start and enable in rc.conf?

No, there is no difference.

PF cannot get IPv6 addresses of tunnel broker interface gif0 when enabled in rc.conf and runs properly when service pf start by root.

It's possible PF is loaded before gif0 is active. Can you post your pf.conf? Sometimes you just need to adjust it a little bit.

 

[Anthie]

Re: Any difference between service start and enable in rc.co

I delayed PF start for 10 seconds to avoid PF starting before gif0 created.
Below is about gif0 rules in pf.conf:

pass from gif0 to any keep state
pass inet6 proto icmp6 from any to any
antispoof for gif0