net

  1. F

    Solved VNET Jail unable to ping 1.1.1.1

    I setup a jail with bsdinstall jail /jails/myjail as in https://freebsdfoundation.org/freebsd-project/resources/introduction-to-freebsd-jails, and setup the /etc/jail.conf contains the following myjail { exec.start = "/bin/sh /etc/rc"; exec.stop = "/bin/sh /etc/rc.shutdown"; exec.consolelog =...
  2. hellfire103

    iwn0 keeps going down

    I am currently running FreeBSD 14.0-RELEASE on a ThinkPad T400. I will often be using my device, when the WiFi will suddenly shut off. i3status reports that it's "down" and wifimgr is blank. I've tried restarting all and any network-related daemons, to no avail, and wifimgr doesn't seem to be...
  3. Don ZioMario

    qemu I'm not able to configure correctly the network interface of qemu when I try to emulate freebsd for arm64 on my jetson nano.

    Hello. it's again me :) I would like to configure correctly the network interface of qemu because I want to grab the connection to internet while I'm installing freebsd 13 for arm64 on my jetson nano. I tried using several methods,but none worked,so I don't know what could be the problem and Im...
  4. S

    Consistent enumeration of network interfaces

    Hi. I'm new to the FreeBSD world. As I'd like to gain some knowledge on this operating system, I decided to install FreeBSD on a little Raspberry board. I plan to use it as a general purpose (headless) home server. Among other things, I'd like to expose it to the open Internet, so I can use...
  5. Bobi B.

    PCI-Express slot speed and utilization?

    Recently, after researching network performance issues, it was assumed the root cause is PCI-Express slot network interface adapter were installed into. Issue were that Intel 10G adapter were not able to TX more than roughly 5G of data. A secondary adapter were since installed and the issue is...
  6. J

    IPFW Transparent proxy squid

    Someone could tell me how I can make a transparent proxy with the IPFW and the squid, it's a bit urgent. Thanks.
  7. Rastko

    Unstable wireless link state

    my dmesg output has a lot of wlan0: link state changed to UP wlan0: link state changed to DOWN wlan0: link state changed to UP wlan0: link state changed to DOWN wlan0: link state changed to UP However, the network appears to be working ok. I once ditched Solaris 11, believing it was...
  8. STOIE

    msktutil + net command

    Hi all, So, I'm configuring a FreeBSD instance to run kerberos via a keytab to AD. Basically, I am at the point of the system being able to register in AD, the machine account is successfully created... (from first glance)... however, the msktutil command dies with it unable to locate the net...
Back
Top