Would like to install LaserGRBL on FreeBSD 13.1 so that I can use it along with my 3D printer Ender-3 with 4.2.7 board.
The laser module is custom made using UV laser of 25mW Sony Diode.
I'm going to make PCBs with it using UV dry film photo resit, known...
Hello, its nice that theres a port for Cura and Prusa Slicer but I like to use programs that are written in C++ so that I can port it into microcontrollers and it's also easier to maintain.
The issue with Prusa Slicer is that it does not have inner hole horizontal expansion compensation. Super...
I am trying to port a 3D printer firmware / daemon called Klipper to run on FreeBSD. So far it all went well until it wanted to <linux/can.h>
I am running out of places to look for that file. I don't see it anywhere in the standard libraries. Is there canbus support in FreeBSD? If so, where can...
I installed cura (3D printing slicer from Ultimaker) with pkg on FreeBSD 12.2 (amd64). I use KDE Plasma 5.20 (if this is relevant).
Cura starts but it freezes:
I can't click anything (already tried Enter and Tab + Enter).
Any way to fix thix...