Request for bcm43142 wifi support in freebsd 15.1

Hello FreeBSD developers,



My internal Wi-Fi card is:

- Model: Broadcom BCM43142
- PCI ID: "14e4:4365"

The card works on Linux using the Broadcom "wl" driver, but I haven't been able to get it working on FreeBSD.

The standard "bwn" driver loads, but it does not create a wireless interface for this device.

I'd like to ask:

1. Is support for this card planned?
2. Is there an existing driver or compatibility solution?
3. Is anyone working on support for this chipset?

I would really appreciate any guidance or suggestions.

Thank you!
 
The standard "bwn" driver loads, but it does not create a wireless interface for this device.
Did you install net/bwn-firmware-kmod ?

bwn(4)
Rich (BB code):
DESCRIPTION
     The bwn driver provides support for Broadcom BCM43xx based PCI/CardBus
     network adapters.
     ...
     This driver requires firmware to be loaded before it will work.  The
     ports/net/bwn-firmware-kmod port needs to be installed before ifconfig(8)
     will work. In most cases the bwn_v4_ucode kernel module from the port
     should be used.  However, if an LP (low power) PHY is being used, the
     bwn_v4_lp_ucode module should be used.
 
The standard "bwn" driver loads, but it does not create a wireless interface for this device.
Assuming this and the firmware is loading you need to make an /etc/rc.conf setting to test from command line.
Then service netif restart or reboot.
#wlans_bwn0="wlan0"

With that in /etc/rc.conf you reboot and can access the device from the command prompt.
ifconfig wlan0 up
ifconfig wlan0 scan
 
Assuming this and the firmware is loading you need to make an /etc/rc.conf setting to test from command line.
Then service netif restart or reboot.
#wlans_bwn0="wlan0"

With that in /etc/rc.conf you reboot and can access the device from the command prompt.
ifconfig wlan0 up
ifconfig wlan0 scan
Thanks for ur suggestion I will try later
 
The reason I recommend you manually bring up the interface is you get to see messages if there are problems.
You also probably want to use /etc/wpa_supplicant.conf and WPA or FreeBSD will try and connect to any open wireless access points if you bring it up the interface.

Also take note of the pciconf -lv status.
if the device shows none@pci0:0:0 then its a driver problem.
If it is showing bwn0@pci0:0:0 for example then the driver is loading but maybe firmware issue.
I think its good to manually load the modules for the driver and firmware.
Just for the console output affirming actions.

For manual connections you might need to run dhclient bwn0 after connecting.
 
Back
Top