Hi,
I am using 11.1-RELEASE-p13 (I know, I should upgrade as soon as possible) on a physical server with 4 x 3 TB sata hard disks.
I wasn't able to disable raid hardware controller, so I created 4 "logical units", in a manner that ZFS could see 4 different disks:
Today I replaced da0, zfs stared to automatically resilver pool, I just noticed that it seems a bit slow:
Is it normal in your opinion?
Thank you very much
I am using 11.1-RELEASE-p13 (I know, I should upgrade as soon as possible) on a physical server with 4 x 3 TB sata hard disks.
I wasn't able to disable raid hardware controller, so I created 4 "logical units", in a manner that ZFS could see 4 different disks:
Code:
# camcontrol devlist
<AMCC 9650SE-4LP DISK 3.08> at scbus6 target 0 lun 0 (pass0,da0)
<AMCC 9650SE-4LP DISK 3.08> at scbus6 target 1 lun 0 (pass1,da1)
<AMCC 9650SE-4LP DISK 3.08> at scbus6 target 2 lun 0 (pass2,da2)
<AMCC 9650SE-4LP DISK 3.08> at scbus6 target 3 lun 0 (pass3,da3)
Today I replaced da0, zfs stared to automatically resilver pool, I just noticed that it seems a bit slow:
Code:
# zpool status
pool: zroot
state: ONLINE
status: One or more devices is currently being resilvered. The pool will
continue to function, possibly in a degraded state.
action: Wait for the resilver to complete.
scan: resilver in progress since Wed May 8 17:26:49 2019
61.5G scanned out of 3.05T at 8.84M/s, 98h25m to go
15.4G resilvered, 1.97% done
config:
NAME STATE READ WRITE CKSUM
zroot ONLINE 0 0 0
raidz1-0 ONLINE 0 0 0
gpt/zfs0 ONLINE 0 0 7 (resilvering)
da0p3 ONLINE 0 0 0
da1p3 ONLINE 0 0 0
da2p3 ONLINE 0 0 0
errors: No known data errors
Is it normal in your opinion?
Thank you very much