Solved usb3 external was usb2 speed, now stuck in usb1

azathoth

azathoth

Code: 
ugen2.5: <Western Digital My Book 1230> at usbus2
umass0 on uhub8
umass0: <Western Digital My Book 1230, class 0/0, rev 2.10/10.65, addr 5> on usbus2
umass0:  SCSI over Bulk-Only; quirks = 0xc001
umass0:7:0: Attached to scbus7
da0 at umass-sim0 bus 0 scbus7 target 0 lun 0
da0: <WD My Book 1230 1065> Fixed Direct Access SPC-4 SCSI device
da0: Serial Number 57584C314836343335333353
da0: 1.000MB/s transfers
da0: 5723134MB (1465122304 4096 byte sectors)
da0: quirks=0x2<NO_6_BYTE>


why would this have only 1meg xfer rate?
was fine yesterday
 
Beastie said:
Is it on a laptop? How is it connected (e.g. through a hub)? Power issues?
Click to expand...

I had plugged in a windows usb drive and tried to mount ntfs-3g, failed.
2 powered down drives were in 2 usb3 ports on external card
I unplugged them both and put the ufs drive into one fo the ports....rebooted and got back usb2 speed.
I think the system must have been stuck with some idea of the windows drive.
I still don't get usb3 speed from the drive.
I have been off n on for a year trying to figure out if my usb3 expansion card is like ok but the motherboard is not usb3.....or something.
I wish I had usb3
 
Code: 
root@realfascism:~ # diskinfo -t da0
da0
        4096            # sectorsize
        6001140957184   # mediasize in bytes (5.5T)
        1465122304      # mediasize in sectors
        0               # stripesize
        0               # stripeoffset
        91199           # Cylinders according to firmware.
        255             # Heads according to firmware.
        63              # Sectors according to firmware.
        57584C314836343335333353        # Disk ident.
        Not_Zoned       # Zone Mode

Seek times:
        Full stroke:      250 iter in   6.542094 sec =   26.168 msec
        Half stroke:      250 iter in   4.659642 sec =   18.639 msec
        Quarter stroke:   500 iter in   7.452643 sec =   14.905 msec
        Short forward:    400 iter in   3.237874 sec =    8.095 msec
        Short backward:   400 iter in   3.425811 sec =    8.565 msec
        Seq outer:       2048 iter in   0.881557 sec =    0.430 msec
        Seq inner:       2048 iter in   0.842960 sec =    0.412 msec

Transfer rates:
        outside:       102400 kbytes in   2.885065 sec =    35493 kbytes/sec
        middle:        102400 kbytes in   2.849899 sec =    35931 kbytes/sec
        inside:        102400 kbytes in   2.899591 sec =    35315 kbytes/sec
 
reboot fixed...not sure if it was related to usb3 addon card and one dirve dropping off confusing everything..
 
You must log in or register to reply here.
Back
Top