I've been following the handbook and forums post and I'm not getting any serial console output. Think I'm getting confused. I'm using a USB-to-Serial adapter for this and I have a null modem cable (Micro Connectors, model M02-233). I am using a Debian laptop on the other end with comms/minicom, serial is set to 9600 8N1 as well. Below are my configs. Any help greatly appreciated.
/boot/loader.conf
device.hints
/etc/devd.conf
/boot/loader.conf
Code:
$ cat /boot/loader.conf
autoboot_delay="3"
console="comconsole,vidconsole"
boot_multicons="YES"
boot_serial="YES"
umodem_load="YES"
hw.usb.template=3
Code:
$ dmesg | grep uart
uart0: <16550 or compatible> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
uart0: console (9600,n,8,1)
Code:
$ grep ttyu0 /etc/ttys
ttyU0 "/usr/libexec/getty 3wire" vt100 onifconsole secure
device.hints
Code:
hint.uart.0.at="isa"
hint.uart.0.port="0x3F8"
hint.uart.0.flags="0x10"
hint.uart.0.irq="4"
/etc/devd.conf
Code:
notify 100 {
match "system" "DEVFS";
match "subsystem" "CDEV";
match "type" "CREATE";
match "cdev" "ttyU[0-9]+";
action "/sbin/init q";
};
Last edited by a moderator: