Bought a new IBM M1015 yesterday, which iI will be using as a pass-through HBA for my 8 WD Reds.
Now I've set everything up, but FreeBSD won't see my 2 TB drives. It does see the 3 TB drives. If I replace a 3 TB for a 2 TB in the same slot, it keeps giving this error message.
All the cables are fine. After this I flashed the M1015 to LSI9211-IT mode, but this also gave the same result.
The WD Red 2 TB disks work fine through the onboard SATA or the old HBA card. Just not through the M1015.
Extra info;
FreeBSD 10.0-STABLE
edit: wrong section.
Now I've set everything up, but FreeBSD won't see my 2 TB drives. It does see the 3 TB drives. If I replace a 3 TB for a 2 TB in the same slot, it keeps giving this error message.
Code:
(probe0:mps0:0:3:0): INQUIRY. CDB: 12 00 00 00 24 00 length 36 SMID 197 terminated ioc 804b scsi 0 state c xfer 0
All the cables are fine. After this I flashed the M1015 to LSI9211-IT mode, but this also gave the same result.
The WD Red 2 TB disks work fine through the onboard SATA or the old HBA card. Just not through the M1015.
Extra info;
FreeBSD 10.0-STABLE
Code:
mps0: <LSI SAS2008> port 0xd000-0xd0ff mem 0xff9fc000-0xff9fffff,0xff980000-0xff9bffff irq 16 at device 0.0 on pci4
mps0: Firmware: 15.00.00.00, Driver: 16.00.00.00-fbsd
edit: wrong section.