I had to play with GRUB2 a bit on my installed Linux to get it to boot FreeBSD, but I sorted that out earlier today and tried to launch FreeBSD for the first time. However during the booting process, it hangs with the following:
Then I go through four repeats of the last three lines before it drops back to
and starts over again. It ran for about 20 minutes before I rebooted back to Linux to search for a resolution, but I didn't see anything quite like what I'm seeing now. I didn't get any hardware errors when trying from a LiveCD environment; could gamepads and printers cause issues now that it's installed?
Code:
ugen4.5: <Unknown > at usbus4 (disconnected)
uhub_reattach_port: could not allocate new device
usb_alloc_device: set address 5 failed (USB_ERR_STALLED, ignored)
usbd_setup_device_desc: getting device descriptor at addr 5 failed. USB_ERR_STALLED
usbd_req_re_enumerate: addr=5, set address failed! (USB_ERR_STALLED, ignored)
Code:
ugen4.5: <Unknown > at usbus4 (disconnected)
uhub_reattach_port: could not allocate new device