I've just installed mDNSResponder on a FreeBSD 10.2 jail.
The port has no user-configurable options that I can find, and no switches.
However, when I start it, it fails to come up:
The host is configured to use IPv6, the jail is not, and has only an IPv4, an alias of my LAN interface:
Any suggestions on how I get this set up?
The port has no user-configurable options that I can find, and no switches.
However, when I start it, it fails to come up:
# mdnsd -debug
Code:
mDNSResponder (Engineering Build) (Feb 1 2016 17:40:48) starting
socket AF_INET6: Protocol not supported
mDNS_AddDNSServer: Lock not held! mDNS_busy (0) mDNS_reentrancy (0)
mDNSResponder (Engineering Build) (Feb 1 2016 17:40:48) stopping
The host is configured to use IPv6, the jail is not, and has only an IPv4, an alias of my LAN interface:
ifconfig
Code:
em0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=40098<VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,VLAN_HWTSO>
ether 00:25:90:86:be:9a
inet 10.0.0.220 netmask 0xffffffff broadcast 10.0.0.220
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
tap0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=80000<LINKSTATE>
ether 00:bd:63:6c:00:00
media: Ethernet autoselect
status: active
Opened by PID 1184
bridge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 02:89:4b:73:89:00
id 00:00:00:00:00:00 priority 32768 hellotime 2 fwddelay 15
maxage 20 holdcnt 6 proto rstp maxaddr 2000 timeout 1200
root id 00:00:00:00:00:00 priority 32768 ifcost 0 port 0
member: tap0 flags=143<LEARNING,DISCOVER,AUTOEDGE,AUTOPTP>
ifmaxaddr 0 port 3 priority 128 path cost 2000000
member: em0 flags=143<LEARNING,DISCOVER,AUTOEDGE,AUTOPTP>
ifmaxaddr 0 port 1 priority 128 path cost 20000
Any suggestions on how I get this set up?