Greetings again,
It worked!
OK, for anyone else that may have had the same question I did;
If you replace every occurrence of:
with
(assuming the root of the archive) it will all work as described.
Given that I was not able to plan for the migration to wireless, but abruptly forced to,
I'll now have to figure out how to make use of it.
FWIW here's the output from the two commands listed in the README, in case it helps anyone
else with this dongle:
NOTE: XX:XX:... has been masked out
Thank you for all your hard work on this driver, PseudoCylon!
--Chris (g_willikers)
It worked!
OK, for anyone else that may have had the same question I did;
If you replace every occurrence of:
Code:
%cd sys/...
Code:
%cd run/...
Given that I was not able to plan for the migration to wireless, but abruptly forced to,
I'll now have to figure out how to make use of it.
FWIW here's the output from the two commands listed in the README, in case it helps anyone
else with this dongle:
Code:
[b]kldload runfw[/b]
firmware: 'runfw' version 1: 8192 bytes loaded at 0xc2c9054c
Code:
[b]#kldload if_run[/b]
run0: <1.0> on usbus0
run0: MAC/BBP RT3070 (rev 0x0201), RF RT3020 (MIMO 1T1R), address XX:XX:XX:XX:XX:XX
run0: firmware RT2870 loaded
run0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
run0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36M
bps 48Mbps 54Mbps
Thank you for all your hard work on this driver, PseudoCylon!
--Chris (g_willikers)