This is a fresh install, trying to set up PPPoE.
From the manual, I did this in /etc/ppp/ppp.conf
I did this in /etc/rc.conf
Doing an ifconfig, tun0 shows the isp's gateway and assigned local ip address
I can ping both addresses from my local console. Takes <1ms for the local, and about 50ms for the gateway.
If I ping http://www.yahoo.com, however I get no resolv. I do know that my isp sends out this info, as a smoothwall installation comes up just fine. I'm currently behind the smoothwall.
You'll notice that I added enable dns as instructed. I also disabled set login, and I added in +debug for the log file.
I am able to read the log file, but I am way to entry level to know what it says. I tried adding lines to rc.conf to turn off the router, I created a start_if.tun0 file, but didn't help. Don't see where that's needed anyway, as tun0 is already up and talking to the isp.
I have since removed those suggestions and back to what I have listed above.
So, how do I go about troubleshooting this issue?
From the manual, I did this in /etc/ppp/ppp.conf
Code:
default:
set log +debug Phase tun command # you can add more detailed logging if you wish
set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.255
enable dns
Verizon:
set device PPPoE:fxp0
set authname admin
set authkey password
set dial
# set login
add default 10.1.2.3
I did this in /etc/rc.conf
Code:
ppp_enable="YES"
ppp_mode="ddial"
ppp_nat="YES"
ppp_profile="Verizon"
Doing an ifconfig, tun0 shows the isp's gateway and assigned local ip address
I can ping both addresses from my local console. Takes <1ms for the local, and about 50ms for the gateway.
If I ping http://www.yahoo.com, however I get no resolv. I do know that my isp sends out this info, as a smoothwall installation comes up just fine. I'm currently behind the smoothwall.
You'll notice that I added enable dns as instructed. I also disabled set login, and I added in +debug for the log file.
I am able to read the log file, but I am way to entry level to know what it says. I tried adding lines to rc.conf to turn off the router, I created a start_if.tun0 file, but didn't help. Don't see where that's needed anyway, as tun0 is already up and talking to the isp.
I have since removed those suggestions and back to what I have listed above.
So, how do I go about troubleshooting this issue?