Hi
Just built a crochet FreeBSD 12 current image for Banana Pi M3 and everything looked OK.
I have installed the image to an SD card but the card does not boot. I have connected to the Tx/RX pins and all I could see was the booting process going in a loop.
Screenshot is below.
Any ideas - highly appreciated.
Thanks
Just built a crochet FreeBSD 12 current image for Banana Pi M3 and everything looked OK.
I have installed the image to an SD card but the card does not boot. I have connected to the Tx/RX pins and all I could see was the booting process going in a loop.
Screenshot is below.
Any ideas - highly appreciated.
Code:
U-Boot SPL 2018.03 (Sep 14 2018 - 19:33:08 +0000)
DRAM: 2048 MiB
Trying to boot from MMC1
U-Boot 2018.03 (Sep 14 2018 - 19:33:08 +0000) Allwinner Technology
CPU: Allwinner A83T (SUN8I 1673)
Model: Allwinner A83T BananaPi M3 Board v1.2
DRAM: 2 GiB
MMC: SUNXI SD/MMC: 0, SUNXI SD/MMC: 1
Loading Environment from FAT... Unable to use mmc 1:0... Failed (-5)
Loading Environment from MMC... *** Warning - bad CRC, using default environment
Failed (-5)
In: serial
Out: serial
Err: serial
Net: No ethernet found.
starting USB...
USB0: data abort
pc : [<bff8fe26>] lr : [<bff8fe09>]
reloc pc : [<4a01be26>] lr : [<4a01be09>]
sp : bbf51c40 ip : bbf5b4ec fp : 00000002
r10: bffb5040 r9 : bbf53ee0 r8 : 00000000
r7 : ffffffff r6 : bbf5a73c r5 : bffb3184 r4 : bbf5a550
r3 : ffffffff r2 : 01c00004 r1 : ffff3f8f r0 : 00000000
Flags: nZCv IRQs off FIQs off Mode SVC_32
Resetting CPU ...
resetting ...
Last edited by a moderator: