adduser command not function - read only mode

D

d_london

Hi everybody,

New to FreeBSD, so apologies if asking a school boy question.

I am trying to use the adduser command, however it's not accepting or executing the process because it says the /home directory is in read only mode. Not sure what is wrong with the current setup. I think by default this would not be read only mode.

I am not using a stand-alone unix box but installed on virtualBox - partition on my drive.

Took a screenshot of the error - attached below

bsd_error.jpg


Advise please what I can do to progress further.
 
You have booted off the install CD again. After the install, remove the ISO image from the virtual CD drive.
 
You must log in or register to reply here.
Back
Top