Hello,
When adding an IP address to a cloned loopback interface in rc.conf (for example lo1) like below:
Is it possible to apply the changes without having to reboot the computer? I tried using:
But ifconfig only started to list the new IP addresses after rebooting the computer.
Thank you
When adding an IP address to a cloned loopback interface in rc.conf (for example lo1) like below:
Code:
ifconfig_lo1_alias1="inet 192.168.185.2/24"
Is it possible to apply the changes without having to reboot the computer? I tried using:
ifconfig lo1 down
ifconfig lo1 up
But ifconfig only started to list the new IP addresses after rebooting the computer.
Thank you