Hi,
I have a FreeBSD 8.2 box running a ZFS mirror over two hard drives (drive0 and drive1). One had a problem and was replaced using the replace command. After the resilvering was completed, the status would still show
After reboot, the same status would still be there and the resilvering would restart from the beginning.
I then detached both drive0 and drive0/old and attached drive0.
Resilvering started again and completed. The status looked normal except for three errors in some files.
But when I rebooted the machine, the resilvering started again and it keeps restarting every time the machine is rebooted.
Why is this happening? And how to stop it?
I have a FreeBSD 8.2 box running a ZFS mirror over two hard drives (drive0 and drive1). One had a problem and was replaced using the replace command. After the resilvering was completed, the status would still show
Code:
Replacing drive0/old and drive0
I then detached both drive0 and drive0/old and attached drive0.
Resilvering started again and completed. The status looked normal except for three errors in some files.
But when I rebooted the machine, the resilvering started again and it keeps restarting every time the machine is rebooted.
Why is this happening? And how to stop it?