I'm doing an automated install, and it all works, except that the partition type is incorrect (so, of course it won't boot). If I pull the drive out and look at it on another machine, I get:
Instead of
The relevant code from my install.cfg is
This is all with a cleared disk:
I do [CMD=""]dd if=/dev/zero of=/dev/ad10 bs=512 count=64[/CMD] before I insert the drive in the build machine.
Am I missing something?
Code:
[brj1-sut]tmp# fdisk -p /dev/ad10
# /dev/ad10
g c969021 h16 s63
p 1 0x03 63 262142433
Instead of
Code:
[brj1-sut]tmp# fdisk -p /dev/ad10
# /dev/ad10
g c969021 h16 s63
p 1 0xa5 63 262142433
A 1
The relevant code from my install.cfg is
Code:
disk=ad4
partition=262143441
bootManager=boot
diskPartitionEditor
ad4s1-1=ufs 41943040 /
ad4s1-2=ufs 41943040 /shared 1
ad4s1-3=ufs 41943040 /upload 1
ad4s1-4=ufs 135168000 /crash 1
ad4s1-5=swap 0 none
installCommit
This is all with a cleared disk:
I do [CMD=""]dd if=/dev/zero of=/dev/ad10 bs=512 count=64[/CMD] before I insert the drive in the build machine.
Am I missing something?